Loading
 
Support Support Home » Software XIMEA cameras » XiCOP » Checking the Camera Firmware and Hardware Revision with xiCOP

Checking the Camera Firmware and Hardware Revision with xiCOP

xiCOP allows to check the connected Camera Hardware Revision.
This can speed up troubleshooting of performance issues.
  • Connect the camera and start xiCop.
  • Wait until all parameters are enumerated
  • Read the Camera Hardware Revision from table at right side at the line marked as hw revision.
  • Read the Camera firmware revisions (CPU, FPGA, FPGA2...).

 

Note: Hardware revisions are supported on cameras MQ, MD.